However, if you are using a timing receiver to synchronize the simulation start time, changes to the settings while in the armed state will be discarded when the simulation starts. For example, it is possible to move a slider to change the initial power of a satellite before the simulation starts. While Skydel is in an armed state, you may change some of the settings. If you clicked the Arm button (instead of the Start button), the simulator will stay in the armed state until you click the Start button. ArmedĪrmed means the hardware is initialized and ready to start. Depending on the selected output and plug-in instances, this state may appear for only a fraction of a second or for up to 10 seconds. Initializing means that the simulator is preparing the plug-in instances for simulation and the radio for streaming this happens when you click the Start button. Clicking the Arm button will initialize the plug-in instances then the hardware and stay in the Armed state until the user clicks the Start button. In this case, Skydel will simply display a message inviting you to add an output and select signals. You may get an error if you haven’t selected an Output. Clicking the Start button will begin the simulation. Ready means that the simulator is ready to start. Voltage Controlled, Temperature Compensated Oscillator Appendix A - Important changes introduced in version 21.3Īmplitude of In-Phase (I) and Quadrature (Q) of carrier Time Offset Too Small (or Sampling Rate Too Low)
Synchronize Simulators with a GPS Timing receiver Synchronize configuration between master and slaves Network Card Driver: 10 GbE Intel X520-DA2
Nvidia GPU Driver for Ubuntu 18.04 and 20.04 (Automatic) Ettus X300/X310 NI USRP-294xR/295xR Firmware (FPGA image) Ettus N310 Firmware (File system and FPGA image) Ettus X300/X310 National Instruments USRP-294xR/USRP-295xR Requirements for National Instruments USRP-294xR/USRP-295xR
0 kommentar(er)
